VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2011-03-03 13:25:16
- cdecaney
- Member
- Registered: 2009-11-17
- Posts: 2
7.1.1 Variables don't load in 1st setup
In 7.1.1 when you open a project, if the first project machine control has variables, they do NOT load.
Vericut has separated and changed the location of the control variables.
They are now located under Configuration - Control Variables.
This is a good change, but it dose not work correctly until you reload the control.
The fix is to just reload the control and the variables then appear.
There is a SCR for this fix, I just mention this because some people read through this forum to find out what troubles people are having with new releases. (like me)
This cost us about 12 hours of down time.
Chris
Offline
#2 2011-03-04 07:26:47
- MustaphaC
- VERICUT Specialist
- From: Le Mans, France
- Registered: 2004-10-14
- Posts: 130
- Website
Re: 7.1.1 Variables don't load in 1st setup
Thank you Chris,
This problem has now been fixed in V712 pre-release
Mustapha
Offline