VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2010-11-03 21:29:56
- Tinhman
- Member
- Registered: 2010-06-26
- Posts: 23
Need help with Rotary Table!!!!
Hi Guys,
I tried to add the rotary table ( A axis) on one of my verital machine and i could not able to get it rotate about its center line ( it rotated off its center).
Could somebody please help me out on this problem?
Thanks in advance.
Offline
#2 2010-11-04 07:14:23
- paehv
- Senior Member
- From: Eindhoven, Netherlands
- Registered: 2005-01-17
- Posts: 167
- Website
Re: Need help with Rotary Table!!!!
Be sure to switch on View Axis > Component
With this you can see the origin (Rotation point) of your A-axis and it helps when adjusting the position.
You can modify position of A-axis Component an of A-axis models independently.
Patrick Delisse
KMWE Aerospace - https://www.kmwe.com
(Vericut V9.5, Siemens NX2206, Campost)
Offline
#3 2010-11-04 13:14:04
- Tinhman
- Member
- Registered: 2010-06-26
- Posts: 23
Re: Need help with Rotary Table!!!!
Thanks guy.
I can see the center of rotation and the center of component did not line up.
I have the rotary table set right at where i wanted. Could you please show me how move and line them up.
Thanks a lot.
Offline
#4 2010-11-04 14:02:25
- paehv
- Senior Member
- From: Eindhoven, Netherlands
- Registered: 2005-01-17
- Posts: 167
- Website
Re: Need help with Rotary Table!!!!
see image
Patrick Delisse
KMWE Aerospace - https://www.kmwe.com
(Vericut V9.5, Siemens NX2206, Campost)
Offline
#5 2010-11-04 14:26:05
- Tinhman
- Member
- Registered: 2010-06-26
- Posts: 23
Re: Need help with Rotary Table!!!!
Thank You Boss.
I got it.
Offline
Pages: 1