VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2010-06-10 22:51:52
- Yodes42
- Member
- Registered: 2010-04-14
- Posts: 5
Pro-E's Vericut 6.2
Hi people,
i have a question does anyone know if you can run machine simulation in the embedded version of vericut that comes with ProE WildFire 4? If so does anyone have any type of training info i could use?
Thanks
Yodes
Offline
#2 2010-06-11 17:33:25
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Pro-E's Vericut 6.2
The embedded version that you get with ProE only allows you to simulate the ProE CLS format. To simulate the G-Code and run Machine Simulation, you need to upgrade the full commercial version of VERICUT.
http://www.cgtech.com/usa/support/license/ptc-upgrade/
Offline
#3 2010-06-11 17:49:51
- Yodes42
- Member
- Registered: 2010-04-14
- Posts: 5
Re: Pro-E's Vericut 6.2
Hey thanks for responce SergeV!
Thats lame, how about in WildFire 5? can i do it in 5?
Offline
#4 2010-06-11 18:10:14
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Pro-E's Vericut 6.2
The embedded version has the same capabilities in every version.
Offline
#5 2010-06-11 18:22:36
- Yodes42
- Member
- Registered: 2010-04-14
- Posts: 5
Re: Pro-E's Vericut 6.2
what would the cost be to upgarde to the full version?
Offline
#6 2010-06-11 18:28:13
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Pro-E's Vericut 6.2
We cannot discuss price on the forum, but if you send your question to link above, we can answer you privately.
Offline
Pages: 1