VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
#1 2010-04-09 05:45:58
- hemmanur
- Member
- From: Bangalore,India
- Registered: 2010-04-09
- Posts: 2
Using Cycle 19 of Heidenhain on Vericut
Hi All,
I am new to the forum and have been using Vericut on an infrequent basis for the past 1 year,simulating programs on a DMU 60P( dual rotary table) with a Heidenhain control.
We have a new post processor for NX6 that outputs a Cycle called Cycle 19 to calculate the work offsets when the table is tilted. This is working well on the machine but not on Vericut.
Is there any of you who have used this cycle on Vericut who can help me run this cycle successfully on Vericut?
Offline
#2 2010-04-09 10:47:24
- VERICUT_USER
- Senior Member
- From: RUSSIA, Moscow
- Registered: 2010-02-10
- Posts: 20
- Website
Re: Using Cycle 19 of Heidenhain on Vericut
I open VERICUT project with HERMLEC30 (heid) from SAMPLES folder VERICUT - working with CYCLE DEF 19! See video. 
Gentleman will walk but never run.
http://www.postprocessor.ru
Offline
#3 2010-04-12 06:24:46
- hemmanur
- Member
- From: Bangalore,India
- Registered: 2010-04-09
- Posts: 2
Re: Using Cycle 19 of Heidenhain on Vericut
Thank you for the reply..i did not know that this sample file existed.I'll study the example project and figure out why my machine on vericut is not able to simulate it properly
Offline