VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

Pages: 1

#1 2009-12-09 14:25:32

MIKEFITZ
Member
From: Chicopee, MA
Registered: 2009-06-18
Posts: 104

Integrex 200-IV ST

Hey all.

I got a new computer a couple weeks ago, and apparently some of my files didn't get transferred to the new one.  roll

Does anyone have a control for a Mazak Integrex 200-IV ST that they would be willing to share with me? If not, no big deal, I can rebuild the one I had, but if someone helps me out, that will save me a good chunk of time.

Thanks in advance
-Mike

Mike
Hoppe Tool

Offline

#2 2010-03-19 08:00:32

ThomasF
Member
From: Austria
Registered: 2009-07-07
Posts: 13

Re: Integrex 200-IV ST

Hello Mike,

did you already get your machine model?
We've just bought a Integrex 300-IV ST and are now looking for a model for this machine.
Would you be willing to share your model / control with me?

Thank you very much.
Best regards,
Thomas F.

Offline

#3 2010-03-19 11:56:47

MIKEFITZ
Member
From: Chicopee, MA
Registered: 2009-06-18
Posts: 104

Re: Integrex 200-IV ST

Hey Thomas.
No problem. My machine is a 200-IV ST, so it might be a little different, but nothing you can't tweak to make right. Also, the control is still a work in progress, but it should be enough to at least get you started. Just let me know where to send it.

-Mike

Mike
Hoppe Tool

Offline

#4 2010-03-19 16:08:33

ThomasF
Member
From: Austria
Registered: 2009-07-07
Posts: 13

Re: Integrex 200-IV ST

Hello Mike,

The difference will mostly be the geometry which is the smaller problem ;-)

You could please send it to *removed*. I'll have a look on it and let you know when I make some improvements.

Thank you very much!!
Best regards,
Thomas

Offline

#5 2010-03-19 18:07:42

MIKEFITZ
Member
From: Chicopee, MA
Registered: 2009-06-18
Posts: 104

Re: Integrex 200-IV ST

Hey Thomas. I just sent an email with a zip folder attached with all the major components and the control. If anything doesn't work, or theres something missing that you need, let me know and ill send that too, if I have it.

Good Luck!

Mike
Hoppe Tool

Offline

#6 2010-09-23 14:19:57

Jeff_Sauers
Member
From: Freeport
Registered: 2006-10-18
Posts: 1

Re: Integrex 200-IV ST

I have Mazak Integrex 300 and 400 -IV ST.  Would either of you be willing to send me the model and controls from the 200 and/or 300?  I would really appreciate it. 

Thanks,

Jeff

Offline

#7 2019-01-11 02:20:54

hm7482
Member
Registered: 2014-04-11
Posts: 2

Re: Integrex 200-IV ST

Hello mike

             Would you be willing to share your Mazak Integrex 200-IV model / control with me?

             E-mail : hm7482@126.com

              Thank you very much.

              Best regards!

Offline

Pages: 1

Board footer