VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2010-02-06 16:43:06
- DNGUYEN1
- Member
- From: KS
- Registered: 2005-06-16
- Posts: 32
Machine Colision.
Hi all,
I was wonderring if I run machine Simulation with Workpiece VIEW instead of Machine/Cutstock , so The Vericut still detect the Spindle colision?
Thanks D Nguyen
Offline
#2 2010-02-08 16:36:38
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Machine Colision.
This is a good question,
Yes, the errors and collisions are detected regardless of the view mode selected. Even if you run VERICUT with no animation, the same errors will be detected. Running the simulation in Workpiece view only will usually run faster than the Machine Cut Stock view. You can always switch back to the machine view when necessary.
Offline
#3 2010-02-08 16:52:37
- DNGUYEN1
- Member
- From: KS
- Registered: 2005-06-16
- Posts: 32
Re: Machine Colision.
Thank you Serge!!
Offline
Pages: 1