You are not logged in.
Pages: 1
i m facing problem regarding machine building in vericut i make a machine name dahlih MCV-720 with 4+1 axis rottory attatchment and working very well on gcodes using controller name fanuc 21 im if i am not using atc and this is the main porblem my atc working is not properly the c axis and the atc both working oon same time when i input the m06 for tool change i am not expert in ,machine code i need help about this problrm
thanks fisa
Offline
when you put M06 into MDI, does the appropriate tool get put in the spindle, with just the motion behaving wierd? If so, what do you have in your control to define M06? For example, in the control that I'm using, I have M06 set to call a tool change subroutine. Does yours have anything to move the C axis? Also, in your component tree, what is your ATC attached to?
Mike
Mike
Hoppe Tool
Offline
i sovle the problem my self regarding controler... but facing another problem look closly this clip when i activate the t5m06 command through mdi for tool change and tool #5 attatch with spindle ....but only for 1st time and the tool changer movement on its right direction but again when i activate the m06 for another tool the tool changer do not work properly and the movment of tool changeer turn to opposite....what happen i dont know.... ia there any one have solution...
asif cad
Offline
Pages: 1