VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2009-12-30 09:26:14
- chrism
- Member
- From: UK
- Registered: 2006-01-24
- Posts: 8
NC Program Review in Machine view
It would be useful if NC Program Review displayed in Machine/Cut Stock view.
This would be useful for seeing collisions with fixture/workholding items which are visible only in Machine/Cut Stock view.
In V7.0 the Line display shows in Machine/Cut Stock view but no tool motions!
Chris M
UK
Offline
#2 2009-12-31 16:44:57
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: NC Program Review in Machine view
Under File >Properties, General tab:
There are 2 check boxes:
Replace Material When Stepping Back
and
Animate Machine When Stepping Back
Because it requires more memory to preserve the cut date and the machine motions, it is un-checked by default for optimum performance.
Offline