VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2009-12-14 19:01:43
- Raymond Majeski
- Member
- From: Charlotte,NC
- Registered: 2006-01-28
- Posts: 2
7.0 Crashing after first move
Has anyone experienced a crash right after the tool is loaded and the machine attempts to make a move. But if I single cycle passed this point it runs like a champ. Weird….. When I mean crash I mean Vericut shuts down without an error or anything the application just disappears.
Jetski from NC
Offline
#2 2009-12-15 18:25:01
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: 7.0 Crashing after first move
Raymond,
I have not seen this specific problem. But if you have a situation where VERICUT crashes, it should be reported to support@cgtech.com. This is the "ideal" situation, you have a temporary workaround and you have a situation that is repeatable. Zip your files, send them to Tech Support with the steps to reproduce the problem.
Regards,
Serge
Offline