VERICUT Users' Forum

jsp_mold

Member

Registered: 2009-12-14

Posts: 1

Configuring Optipath.

Hi all,
This is my first post.  I have a question regarding optipath.  We are making a big jump from Vericut 5.4 to Vericut 7 and I need some help configuring our optipath library.  In version 5, under optipath control we have the field to specify the optipath library file as shown circled in red below.  The second image shows the dialog as it appears in Version 7.  How do I go about specifying the file to use for optipath?  TIA

SergeV

Senior Member

From: Irvine, CA

Registered: 2004-10-08

Posts: 507

Website

Re: Configuring Optipath.

I could not see you images, but I think I do not need to see them to reply:

The main difference is that since VERICUT 6.0, the OptiPath library and the Tool library have been merged into the tool library (tls).

If you open the 5.0 User file, all the files will be loaded and merged. When you save your files into 7.0, the tls will now contain all the OptiPath settings under each tool.

I would recommend that you refer to an OptiPath training session to familiarize yourself with the new interface afterward.