You are not logged in.
Pages: 1
Hey all. I'm trying to cut a part on a Mazak Variaxis 630. My program has all the appropriate commands (G00, G01) in the appropriate places, and calls out feedrates of 10-15ipm. In the status window, the feedrate is displayed as expected, except it still says the motion type is rapid, and the rapid symbol is lit at the bottom of my viewer, and the fast feed error pops up in the logger, indicating that at no point does my machine recognize that it is supposed to be in linear motion as opposed to rapid. I just had to rebuild some of my control from a computer switch, and I believe I must have set up something in the Word/Address window incorrectly, although I'm not sure what. Any ideas or suggestions would would be greatly appreciated.
thanks,
mike
Mike
Hoppe Tool
Offline
Nevermind everyone, I'm just dumb. for some reason not having the coolant on was preventing the job from going into linear motion. I got it all straightened out now, though.
Thanks anyway! :oops:
Mike
Hoppe Tool
Offline
Pages: 1