VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2009-11-30 19:13:47
- pamccrac
- Member
- From: Houston, TX
- Registered: 2006-06-05
- Posts: 10
Mori Seiki SL403 - MSX 501III
needing to build SL403 with MSX 501 and not sure what "sample" control is similar... any help would be apprecitated. :?
Offline
#2 2009-11-30 23:52:53
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Mori Seiki SL403 - MSX 501III
Start with a Fanuc 15t_t.ctl. it is very close to your control and it is configured for the turret.
You can refer to training session 105 for a step-by-step on how to build a lathe.
Offline
#3 2009-12-01 12:54:11
- pamccrac
- Member
- From: Houston, TX
- Registered: 2006-06-05
- Posts: 10
Re: Mori Seiki SL403 - MSX 501III
That's what I'll do. Thanks again!!!
Offline
Pages: 1