VERICUT Users' Forum

yuehuahrbin

Member

Registered: 2009-10-30

Posts: 3

Help！！

turning ： C axis replace main axis in order to achieve
non-rotational symmetry processing

Is the aim described above put into practice？

Thanks very much for your help！

SergeV

Senior Member

From: Irvine, CA

Registered: 2004-10-08

Posts: 507

Website

Re: Help！！

Hello,

You can look in the Samples folder installed with VERICUT, there are many example of turning simulation. We have some example of mill-turn machines with turning and milling with a C axis.

yuehuahrbin

Member

Registered: 2009-10-30

Posts: 3

Re: Help！！

to achieve non-rotational symmetry processing by turning ！

Turning：just turning ，not mill！

I need to put the workpiece on C axis （not main axis because the main axis is speed control ，not angle control ， I need angle control ，so choose C axis）！

when C axis rotating which is controlled  through angle ， error is interference not  cutting ！

Is the aim described above put into practice？

my English is not very good ，so  do you understand ？

Thanks very much for your help！

SergeV

Senior Member

From: Irvine, CA

Registered: 2004-10-08

Posts: 507

Website

Re: Help！！

We have a macro to activate this cutting mode, the macro is ModeAsymTurningOnOff. You can activate it with an override value of 1 or a value of 0 to deactivate it.

We have technical support in China, you can contact them if English is a problem.

yuehuahrbin

Member

Registered: 2009-10-30

Posts: 3

Re: Help！！

I've solved the problem

Thanks very much ！