You are not logged in.
Pages: 1
I am running a mill turn program through Vericut. Program looks good but the turning spindle is not turning and my blank or stock is not updating as each operation runs. It runs fine for one of my coworkers with the spindle moving and the blank updating. Is there a setting in Vericut I am missing? Mike
Offline
Hi Mike,
Assumed you have a Machine Simulation license, you probably only have the view type "Machine" active? Not "Machine/CutStock"?
If you right click in the view and choose Display Axes/Spindle Direction - is there an arrow "wrapped around" the axis of the turnings table?
Svante Eriksson
System owner
GKN Aerospace Engine Systems Sweden
Vericut 7.2.1, 7.3.4, 7.4 - NX 9.0.3
Offline
Pages: 1