VERICUT Users' Forum

fishbait

Member

From: Sidney, B.C.

Registered: 2005-03-01

Posts: 1

Website

Vericut for FADAL 3020

Hi there,  I'm looking into Vericut to use with a FADAL 3020 / Mastercamv9.1.   My concern is the control uses Fadal's own pseudo-g-code (i.e. E1 instead of G54)

My question is: Can vericut prove out NC code for the Fadal.

TIA, Mike

P.S. is there a demo version I can try out???

TomB

VERICUT Specialist

From: Ann Arbor MI

Registered: 2004-10-09

Posts: 21

Website

Re: Vericut for FADAL 3020

Mike,
Not a problem. This is simply a different method of using work offsets. Vericut can be configured to handle a wide variety of work offset methods.

Vericut also has a MasterCam interface option available that can automatically launch Vericut and transfer your tools and cutterpath (G-Code or NCI) directly to the Vericut session.

Regarding a demo version, you'll need to contact your local sales engineer. You can contact CGTech at (949)753-1050 and they'll have your local rep get in touch with you.

Regards,
Tom