VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2009-08-11 13:12:45
- kad7751
- Member
- Registered: 2009-08-11
- Posts: 1
CYCLE/DEEPHL Error
I get this error when I use the CYCLE/DEEPHL statement in my tape.
CYCLE/DEEPHL,1.9,.1,20,IPM,.1,LOW
Statement at line 2371, Unable to find matching CYCLE definition.
And so, Vericut doesn't show the drill cylce motion.
Any suggestions????
Thanks
Offline
#2 2009-09-25 23:37:29
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: CYCLE/DEEPHL Error
Project > Process Options > APT Settings...
Cycles tab
-Make sure the Cycle Set matches your program Type (CATIA APL, UG CLfile, etc)
-If it matches, and gives you the error
Cycle Definitions...
find the CYCLE/DEEPHL definition that is close to yours
copy the line starting with USEWITH:... and the CYCLE/DEEPHL...
Modify it to :
CYCLE/DEEPHL,#fedto,#rapto,#fedupm,IPM,#step,LOW
Offline
Pages: 1