VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
#1 2008-12-13 15:18:33
- NightStalker
- Member
- Registered: 2008-09-14
- Posts: 5
Auto-Diff -->Gouging Comparison Tolerance
Hello everyone. I am new to Vericut and I love this software!
But I have a small problem regarding Gouging check in Auto-Diff, hope you can help me.
My situation:
Alright, I have a machined model(stock) and a design model, and I need to compare whether there is any gouging present in my stock or not.
I notice that under Auto-Diff --> Comparison Tolerance, there is a Gouge value for us to input.
My question:
Does this value consists of the sum of both Out and In-tolerance (which are the Upper and Lower values away from the Norminal surface)?
Or is it a value from the Norminal surface to the Out-tolerance surface?
Thankyou for your kind attention.
Offline
#2 2008-12-15 08:00:57
- MustaphaC
- VERICUT Specialist
- From: Le Mans, France
- Registered: 2004-10-14
- Posts: 130
- Website
Re: Auto-Diff -->Gouging Comparison Tolerance
The value to put for 'Gouge' in AUTO-DIFF is the direct value for In-tolerance.
If you select 'Excess' then you can set a different value for Out-tolerance.
Mustapha
Mustapha
Offline
#3 2008-12-17 10:41:35
- NightStalker
- Member
- Registered: 2008-09-14
- Posts: 5
Re: Auto-Diff -->Gouging Comparison Tolerance
Ok, got it. Thanks very much :wink:
Offline