VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2008-06-06 11:50:56
- paehv
- Senior Member
- From: Eindhoven, Netherlands
- Registered: 2005-01-17
- Posts: 167
- Website
Cut fixture
Were is the command to cut the fixture?
Normally vericut only colors a collision with tool and fixture red, but is there a command to actually remove the fixture material when cutting into it?
Thanks,
Patrick Delisse
KMWE Aerospace - https://www.kmwe.com
(Vericut V9.5, Siemens NX2206, Campost)
Offline
#2 2008-06-06 12:14:12
- stpendl
- Senior Member
- From: Nussbach, AUSTRIA
- Registered: 2005-07-12
- Posts: 134
- Website
Re: Cut fixture
There was in v5, but it is removed for v6.
Stefan Pendl
Systemmanager CAD/CAM
Windows 10 x64 Edition, Vericut 9.0
Offline
#3 2008-06-06 15:51:45
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Cut fixture
in 6.2, you will have an option "OK to cut fixture" with a value for "Maximum Milling Depth".
It will be in the component attributes of the fixture.
The advantage of this method is that you can separate the fixture back plate from the clamps and bolts. You can allow a certain depth of cut in the fixture back plate but any contact with the clamps will generate an error.
Offline
Pages: 1