VERICUT Users' Forum

DWARD

Member

From: Florida, USA

Registered: 2006-10-05

Posts: 7

Okuma G85 U command

Hey all,
   I recently updated from 6.02 to 6.12 and now my stock allowance for ID rough G85 cycle is simulated the same as though it were an OD cycle. Ie-it is leaving stock in the wrong direction. I am using the same control and part program as I just programmed this in 6.02. Is there a macro change or parameter setting in 6.12 that I cannot find? Thanks for your help.
Dave