VERICUT Users' Forum

mark876543

Member

From: Dallas, Texas

Registered: 2007-01-06

Posts: 1

Fast Feed checking for each tool

We use 5.4.5 machine sim in milling shop.  The .pun files are our motion files, so any vericut fastfeed pprint statements are lost.  There is a field for fastfeed in the Setup, Motion panel, but this is just one setting for the whole program, so you have to pick the fastest feed used in your whole program, else be manually changing it at each tool, which no one does.  What we would like is if there were a way to associate a max feedrate limit to each cutter assembly in our library, and have it check for this during sim, and alarm if exceeded.   Anyone know of a way of accomplishing something like this?

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Re: Fast Feed checking for each tool

APT/CLS => PPRINT/VERICUT-MODAL FASTFEED=100

G-code (fanuc) => (VERICUT-MODAL FASTFEED=100)

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."