VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2007-08-02 14:50:17
- krystof.lis@giddens.com
- Guest
5 Axis Opti Path
I was wondering can you run opti path on a 5 axis operations, because every time I do it will cut all the inverse time feed rates down about 75% while all the 3 axis operation it does optimize all the feed rate.
Thanks
#2 2007-08-02 21:29:31
- krystof.lis@giddens.com
- Guest
Re: 5 Axis Opti Path
Thanks Leo from CG Tech support, it was my control file in control settings, motion, the maximum inverse time was set to low
#3 2007-08-02 22:22:31
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: 5 Axis Opti Path
Thank you for posting the solution
Offline
Pages: 1