Vericut and 3D-Connexion devices

ejw · 2007-07-30 12:54:09

Has anyone used a 3D-Connexion device ,like a Space Navagator, with Vericut. If you did do you like it?

stpendl · 2007-07-30 14:17:52

You will have to use version 6.x of Vericut to have good performance in the work piece view, since you can enable OpenGL acceleration for that views.

I think it is better to save some custom standard views and use them, which is much faster than using 3D input devices.

SergeV · 2007-07-30 22:40:01

A lot of issues with the 3D connections were fixed in VERICUT 6.1.x.
I have been using my SpaceTraveler (smaller version of the Space Ball) for about 2 months and have not had any adverse effects.

If you have 6.0.x, I would recommend that you wait until you go to 6.1.x because of some stability problems.

Like any such devises, it is always recommended that you install the latest drivers.

ejw · 2007-07-31 12:18:03

stpendl and SergeV, thanks for your replies.
I'm currently using 6.0.2 so I'll wait untill 6.1.x is installed.

stpendl · 2007-07-31 15:18:06

I would recommend to install VC 6.1.1, which we are currently running.

There have been several issues addressed, which kept me from using the 64-bit Windows version.

My users are now happily using 64-bit VC on Windows XP x64

SergeV · 2007-07-31 15:20:59

Thank you stpendl,

We like the

VERICUT Users' Forum

#1 2007-07-30 12:54:09

Vericut and 3D-Connexion devices

#2 2007-07-30 14:17:52

Re: Vericut and 3D-Connexion devices

#3 2007-07-30 22:40:01

Re: Vericut and 3D-Connexion devices

#4 2007-07-31 12:18:03

Re: Vericut and 3D-Connexion devices

#5 2007-07-31 15:18:06

Re: Vericut and 3D-Connexion devices

#6 2007-07-31 15:20:59

Re: Vericut and 3D-Connexion devices

Board footer