VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2007-06-14 17:49:56
- tirelady
- Member
- From: North Carolina
- Registered: 2006-12-04
- Posts: 8
Long hang time for tool change.
Using 6.1.1 as compared to 6.0.3 - during visual of tool change it seems we have an extended hang time between changes. Have adjusted tolerances, made translucent, increased skip steps etc. cannot seem to get the tool to change out any faster. We are running with same work stations as were with 6.0.3 and need to find setting or fix for watching stopped tool way too long on screen (sometimes as long as 30 seconds). 6.0.3 was much more efficient. Thanks in advance for any suggestions.
Offline
#2 2007-06-15 22:34:10
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Long hang time for tool change.
Hello TireLady,
Seems like a configuration problem to me, I have not noticed this behavior or heard about it. Send it to Tech Support, they might be able to reproduce and find the cause.
Serge
Offline