VERICUT Users' Forum

girishnilange

Senior Member

From: Bangalore, India

Registered: 2006-08-26

Posts: 23

Displaying Operator-Message in the message area

I am trying to splash an operator-message in the message area during the simualtion run.
I used the "MessageMacro" action macro for this. But it invariably spashes the message as an "Error" followed by the intended text.
I read in the HELP and learnt that the messagemacro decides on the type by the input numeric value, by overriding with a value aslo the result doesnt seem to change.

Please advice.

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Re: Displaying Operator-Message in the message area

Process options  >> message tab

send info messages to the g-code log and logger

depending on the control,  may have to tweak comments in words table

read up on begin comment, and begin type II in the help

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."

girishnilange

Senior Member

From: Bangalore, India

Registered: 2006-08-26

Posts: 23

Re: Displaying Operator-Message in the message area

Thank you Dave.
By changing option in the 'process options' messages tab it worked.
the type of the message is decided by the override value as rightly mentioned in the help.

Girish Nilange