VERICUT Users' Forum

girishnilange

Senior Member

From: Bangalore, India

Registered: 2006-08-26

Posts: 23

Overtravel Limits

I want the axis to stop at the overtravel limit value (specified in machine settings) even though the commaded value is beyond the limit.
e.g. ---
Z overtravel limit is 50.0
The NC Block reads as - G0 Z75.0
Then the controller should limit the Z to 50.0 and continue to the next block in the NC Program.
Kindly suggest method/s to go about this.

-Thanking you in advance.