You are not logged in.
Pages: 1
Hi all,
Was wondering if anyone here has expanded on the CYCLE800 subroutine that CGtech supllied with the 840D control in version 6. Im specifically looking for one that includes Mode 93 (solid angle). I've had a best guess at it but I'm not very confident that I've done it right!
Any help appreciated...
Dan
Current version: Vericut 7.0.3
Offline
Hi,
I have used the new CYCLE800 SPF supplied with v6. But I have used it in a ctl for 5.4.5. Works fine since there are no new macros in the SPF. However I have edited it a bit e.g. corrected some mistyping.
The mode I'm using is 39 in a B-axis Deckel Maho 200FD.
But I'm not sure what you mean with mode 93.
Svante Eriksson
System owner
GKN Aerospace Engine Systems Sweden
Vericut 7.2.1, 7.3.4, 7.4 - NX 9.0.3
Offline
Pages: 1