VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2006-10-24 01:10:01
- sureshnaiduc
- Member
- From: Auckland
- Registered: 2006-08-17
- Posts: 32
- Website
Measuring the depth of a hole
does anyone know measuring the depth of a hole using x-caliper ?
Offline
#2 2006-10-24 14:19:48
- DaveF
- Senior Member
- From: Valencia, CA
- Registered: 2005-08-20
- Posts: 304
Re: Measuring the depth of a hole
Hmmmmm, not exactly. 
I would do distance between plane & point
zoom in and do a section, to get as close as possible to the point of the drill, or corner
of course, Autodif will give you good comparason to model within tenths.
Anyone got a better way ? :?
ps, some friends of mine came from down under, but like a boomerang, they went back
Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."
Offline
Pages: 1