VERICUT Users' Forum

sureshnaiduc

Member

From: Auckland

Registered: 2006-08-17

Posts: 32

Website

Counter Sink

Hi Vericutter's

There was a old request in the forum abt counter sink measurement. It was added to the enhancement request in 2004. Does any one know abt it. is there any way we can measure the counter sink dimentions. has it been added in 602 .

plz giude me.

cheers

vhubbard

Beta User

From: Dallas, TX

Registered: 2004-11-11

Posts: 222

Website

Re: Counter Sink

I ran the 6.0.2 demo part, ran xcaliper and feature history.
It reports a cone center, vector and 1/2 the included angle, but not the diameter.    I want the major diameter to be reported.  :cry:

If you see a enhancement request you like.   Throw your companies weight behind it and turn it in again under your name, to customer support.  That is the best way I know to vote for enhancements.

A workaround until the enhancement.  Define Countersinks to be the exact diameter you want to cut, then if they go too deep, you will see a counterbore at the top of the Countersink.