VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2006-09-27 20:28:41
- manu
- Member
- From: BERGAMO
- Registered: 2006-08-18
- Posts: 9
GAGE OFFSET
HELLO DEAR FRIENDS
can you give me a little help?
can you explain something about the funtion "GAGE OFFSET"?
it gives me some problem!
thank'you very much!
Offline
#2 2006-09-28 01:00:41
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: GAGE OFFSET
Hello Manu,
the Gage Offset is the distance between the tip of the tool (driven point) and the gage point (reference point where tool loads in the spindle).
The Gage offset comes from the tool definition in the tool library.
This is the general definition. What is the problem you encounter?
Serge
Offline
#3 2006-10-01 20:45:51
- manu
- Member
- From: BERGAMO
- Registered: 2006-08-18
- Posts: 9
Re: GAGE OFFSET
HELLO THANK YOU FOR YOUR ANSWER
I UNDERSTAND WHAT YOU MEAN, BUT IN A TURNING MACHINE THERE ARE 12 POSITIONS IN THE TURRET. FOR THE FIRST POSITION IT'S ENOUGHT TO APPLY THAT YOU SAID, BUT IN THE OTHERS DOES NOT WORK; OR I CAN'T CALCULATE IN THE RIGHT WAY.
ANYWHERE THE NC USED BY ME IS " FAN 12 CTL "
THANK YOU AGAIN
BYE
Offline
Pages: 1