VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2006-09-07 22:25:21
- sureshnaiduc
- Member
- From: Auckland
- Registered: 2006-08-17
- Posts: 32
- Website
Control File
Hi Vericutters.
I am looking for Haas 4 axis machine and controller file. I could use generic 4 axis machine from the library. I an unable to find right controller. Any ideas ?
Offline
#2 2006-09-11 21:53:44
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Control File
Look in the Library folder, there is a Hass control "hascnc.ctl"
Serge
Offline
#3 2006-09-11 23:35:30
- sureshnaiduc
- Member
- From: Auckland
- Registered: 2006-08-17
- Posts: 32
- Website
Re: Control File
Hi Serge.
Thx for help. What machine file can i use it to. i need it for a haas 4 axis machine. Also we are using engraving tool, the letters are not shown on the cut stock.
cheers for now
suresh
Offline
#4 2006-09-12 00:14:31
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Control File
look in our samples, you can use any of the 4 axis machines. You can also build it yourself.
In the training sessions there is a session about building a 4 axis machine step-by-step
good luck.
Serge
Offline
Pages: 1