VERICUT Users' Forum

BillH

VERICUT Specialist

From: Irvine, CA

Registered: 2004-10-08

Posts: 146

Website

Unigraphics to VERICUT Interface and Unigraphics NX3

I just did a quick test this morning and it appears VERICUT's 5.4.2 Unigraphics to VERICUT Interface works correctly with Unigraphics NX3 on Windows. I did not test the original version released with VERICUT 5.4, but I suspect it works ok too.

So, if you are currently using the interface with Unigraphics NX2 on Windows, it should continue to work just fine with NX3.

If you have a "standard" installation (ie don't customize any of the UG or VERICUT installed files) and install NX3, the ugv_nx2.bat file (the file that launches UG with the VERICUT interface settings) will launch NX3 since the .bat file is setup to run the most recently installed UG version.

We will do more testing on Windows and test the other UNIX platforms as well.