VERICUT Users' Forum

dannybradford

Member

From: Little Rock, AR

Registered: 2006-04-06

Posts: 1

Question on functionality

I am wondering if Vericut or any other CGTech software will take several  NC programs built each from a different Engineering part and nest the programs? In other words I want to nest programs, not parts. The parts are honeycomb aluminum flat panels, in case it matters.

If this is the incorrect context for this question please direct me to the correct forum and I apologize in advance.

Thanks for your time.

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Re: Question on functionality

If I understand you correctly, you are trying to run several parts on one piece of material.

If so , than running G-code should do it fine. the control can recognize fixture offsets. 

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."

GavinP

VERICUT Specialist

From: UK

Registered: 2004-10-14

Posts: 58

Website

Re: Question on functionality

Vericut will not calculate the nesting of components in a billet but will simulate the results.