You are not logged in.
Pages: 1
Trying to s/up a DMU50 Evo. with Heidenhein V410 Mill Plus control. When I enter a G7 rotation command the machine simulation is correct but the axis' rotation is not. Ex: I created a basic block stock and give the following command: "G7 A5=90. B5=0. C5=90. L1=1" whcih should place the front face pointing up but my Z axis is now pointing back or Y+? Is there something I am missing.
Offline
Never Mind,,,,,I figured this out on my own. I forgot to set the MCH_CONFIG variable to "1" for the 50 Evolution.
Offline
Pages: 1