VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2008-01-25 15:58:22
- rmoreno
- Member
- Registered: 2004-12-20
- Posts: 3
Documentation for Cyclesxxxx (Bore, BoreDrag, BoreOrient)
Is there any detailed documentation for the Cyclesxxxx macros. I would like to know what Vericut does different for Bore vs BoreDrag ve BoreOrient. I currently use the CycleBoreShiftFlags and CycleBoreSpindleOnOffFlag macros to define cycle motion for the CyclesBore macro and it works well. I would like to find out what the other Bore macros are intended to simulate.
Thanks,
Rich
Offline
#2 2008-01-25 19:12:52
- jsmillett
- Member
- From: Chatsworth, CA
- Registered: 2005-02-25
- Posts: 42
Re: Documentation for Cyclesxxxx (Bore, BoreDrag, BoreOrient)
samples\boring_bar.VcProject
-> Configuration -> Word/Address
Cycles G85 G86 G87 G88 G89 and Register Q
Jerry Millett
Offline