VERICUT Users' Forum

zac

Senior Member

From: NY

Registered: 2007-05-19

Posts: 64

CATV 6.1 (CATIA/VERICUT Interface)

Hello everybody:

When I run CATV script from my CATIA session it's taking a lot of time to figure out what directory is it and who knows what else :?  and automatically fills in the 'Folder for new files', 'Base name for new files', 'Part Operations' fields and if I have ran the script previously from the same CATIA session it'll fill up all the 'Design' 'Fixture' and 'Stock' fields. Well its a good thing but not always I want that feature. There are times that I waited for as long as 10 to 15 minutes fot the Interface to identify all the stuff and most of the time I don't want that. :x 

Does any body know where I could turn off this feature of CATv and it let me pick what I want and what new file name and where to go and Most Importantly which  'Part Operation'. Say if I have multiple CATIA sessions open CATv will automatically identify one among them and what should I do to change the Part Operation ??? ???

Thanks ahead for your advice and suggestions.

Regards

zac.

zac

Senior Member

From: NY

Registered: 2007-05-19

Posts: 64

Re: CATV 6.1 (CATIA/VERICUT Interface)

Anybody ..????