VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2007-03-06 18:29:50

peterbrown77
Member
Registered: 2004-11-11
Posts: 18

Vericut 6.1 and ProE Wildfire 3.0

I just finished my test installation of Vericut 6.1.  We are currently using 5.4 in production without issues, and this is our first try of 6.x.

It appears to function correctly with Wildfire 3.0 when doing Machine Simulation (G-Code).  We use solid tool assemblies and the transfer appears to work correctly.  Gauge Z length is taken into account, and our old .mch and .ctl files work.

However, when running CL Data (not posted G-Code) there is an issue:  While the Tool Manager shows the correct Gage Point value, the simulation is driving the tool entirely through the part.  This is not behavior we saw in Vericut 5.4.

This appears to happen only in holemaking cycles.

Any thoughts?

Offline

Board footer