VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2006-12-15 08:17:03
- rambow
- Member
- From: CHINA
- Registered: 2006-10-08
- Posts: 2
motion speed problem
there is a question confused me for a long time,so please help me out.
the problem is that seval times when i simulate a multiple axe milling program , the machine move so slowly when it need rotary the table .but it plays right when x y z moving. thank u!
ask for more!!!
Offline
#2 2006-12-28 20:56:34
- JoelS
- Member
- From: Wichita, KS
- Registered: 2005-12-14
- Posts: 6
- Website
Re: motion speed problem
rambow,
If you have the Output Intermediate Points active in the Control Settings > Rotary tab, then...
Check the "Rotary Rapid Motion Tol." setting in the G-Code Settings > Settings tab.
The smaller the number - the more intermediate points that are ouput, which slows down the rotary simulation.
Offline
#3 2007-01-31 05:44:43
- rambow
- Member
- From: CHINA
- Registered: 2006-10-08
- Posts: 2
Re: motion speed problem
Thanks a lot!
ask for more!!!
Offline
Pages: 1