VERICUT Users' Forum

KUMARAVEL.S

Member

From: BANGALORE - INDIA

Registered: 2006-07-24

Posts: 1

Can I able to detect the wrong entry of cuttting parameter

Dear All,
My client wants me use the different Cutting parameter for a tool in different condition. (i.e) 1. when cutter is in 100% engagement 2.when cutter is in 50% engagement 3. when it is in  floor finishing.
      Can I able to customize the vericut  to detect, whenever there is any wrong entry of my cutting parameter ( Depth of cut,Feed,Width of cut)for a particular working condition.

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Re: Can I able to detect the wrong entry of cuttting parameter

Talk to your sales rep about Optipath.

It will modify the programs feeds based on cutting conditions, replacing the operators need to drive the tool with the feed knob.

take the training.

I saved 15% cycle time in my ist try at it! :wink:

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Re: Can I able to detect the wrong entry of cuttting parameter

Oh yeah, and another thing.

New in version 6, you can get errors for a Variety of conditions. You check the "Check cutting limits" box, in the motion tab.

You did not mention the version you are running.
Good reason to upgrade.
:wink:

limits are set in the Optipath Record

here you set Check cutting limits"

 

here you set all min / max limit conditions

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."