You are not logged in.
I using a fanuc16m control in Vericut for Kiva 5ax
How to defintion G52(Local Coordinate System Setting)in vericut?
that is the definition of a the Work fixture offset, the part origin.All the move which appears after a G52 definition will use the X, Y and Z coordinates defined in the G52 line as new origin, new zero.
This my programe:
%
N1 G0 G17 G40 G54 G90
N2 G49 G53 Z0
N3 M6 T4
N4 M3 S10000
N8 G0 B66.054 A-137.227
N9 G52 X-91.318 Y0. Z-33.882
N10 G90 G0 X-3.928 Y9.115
N12 G43 Z38.882 H4
N13 Z7.419
N15 G0 Z2.419
N16 G1 Z-22.581 F500.
N17 X-2.453 Y9.167 Z-21.507 B65.356 A-138.005 F1542.6
N18 X-0.97 Y9.229 Z-20.458 B64.662 A-138.791 F1538.41
N19 X0.519 Y9.303 Z-19.436 B63.972 A-139.586 F1534.08
N20 X2.139 Y9.457 Z-18.317 B63.201 A-140.492 F1689.98
Offline