VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2023-04-13 18:31:33
- KArnold
- Member
- From: Michigan
- Registered: 2006-01-30
- Posts: 2
- Website
Using KenTip drills - avoiding breaking through
We are using KenTip drills and these drills like to drill into solid only, no start holes, no breaking through.
Is there some logic I can put into vericut to give me a warning that the drill is breaking through into an opposing hole?
Offline
#2 2023-04-21 16:54:47
- Tony
- Moderator
- From: Crewe, England
- Registered: 2007-02-20
- Posts: 181
- Website
Re: Using KenTip drills - avoiding breaking through
Good question.
Is this in a canned cycle or G1 / G0 long hand from a CAM system?
Tony
Offline