VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2022-01-13 14:33:00

paehv
Senior Member
From: Eindhoven, Netherlands
Registered: 2005-01-17
Posts: 154
Website

Where to find "Initial Machine Location"

The Initial Machine location was part of the Machine Settings > Locations.
Were to find this setting in version 9.2.1 ???


Patrick Delisse
KMWE Aerospacehttp://www.kmwe.com
(Vericut V9.2.1, Siemens NX1980, Campost)

Offline

#2 2022-01-14 16:19:00

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 141
Website

Re: Where to find "Initial Machine Location"

Project > Offsets > Locations


Tony

Offline

Board footer