VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to:

You are not logged in.

#1 2004-11-11 15:56:58

Registered: 2004-11-11
Posts: 11

Letter and number drill input

Regarding tool diameter input when defining a drill : is it possible to
enhance Vericut so that a letter or number size can be input and
Vericut will input the drill size from a stored table? What I had in mind
was being able to input the letter R (case shouldn't matter)
and having Vericut insert the drill size of .339". In the case of number
drills, use a # symbol with the number size i.e. #5 and have Vericut
input a drill size of .2055" etc...just thought that this would be a
handy tool to have for doing drill definitions...any thoughts on the
on the idea?




Board footer