VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

Pages: 1

#1 2015-02-19 14:15:15

Alone3
Member
Registered: 2015-01-01
Posts: 3

Reference point

How to make a home position of the two reference points G28-G30 .G28 outputs the coordinates in machines zeros G30 outputs the coordinates in machines X-350 Y-300 Z0.
G28 works well, how edit home position G30?

Offline

Pages: 1

Board footer