VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2014-11-07 08:29:44
- matteo
- Member
- Registered: 2014-10-14
- Posts: 2
vcpost how to ?
Hi All
I'm new of Vericut. How I can create a post processor in Vericut (I think is vcpost file) ?
I have a APT CREO program and i want post a gcode.
Thank
Bye
Offline
#2 2014-11-13 23:33:42
- Tony
- Moderator
- From: Crewe, England
- Registered: 2007-02-20
- Posts: 181
- Website
Re: vcpost how to ?
Check the help in Vericut there is a section under Vericut Development Tools > CGTech Post Processor Help > Introduction to the CGTech Post-Processor
Tony
Offline
Pages: 1