VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2014-03-18 14:21:02
- prem1442000
- Member
- Registered: 2014-03-13
- Posts: 2
Cutstock Rotation in Trunnion Tool
I am new in Vericut and would like to know if I could Automatize Rotation of Cutstock on my trunnion tool using Trunnion Csys.
I have one NC tape which machines all four sides of a part as it is manually rotated after that side is machined.
Offline
#2 2014-03-21 12:55:35
- MustaphaC
- VERICUT Specialist
- From: Le Mans, France
- Registered: 2004-10-14
- Posts: 130
- Website
Re: Cutstock Rotation in Trunnion Tool
Have a look at "...samples\reposition_via_comments.vcproject". You can use comments to move the stock from a Csys to another but you need to configure the control in order to correspond to the comment you want to use in your single NC program
Mustapha
Offline
#3 2014-03-25 20:25:41
- prem1442000
- Member
- Registered: 2014-03-13
- Posts: 2
Re: Cutstock Rotation in Trunnion Tool
Thank you for directing me towards correct resource, it is really helpful. I was able to do what I wanted.
Offline
Pages: 1