VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2005-06-01 18:09:52
- DC Gorn
- Senior Member
- Registered: 2005-06-01
- Posts: 20
A new guy
Just wanted to say Hi. I am new to Vericut due to a new job. I hopfully will get to class this summer. I will be trying to self train till then. I plan on reading all the posts, Thanks in advance.
Also a sig check 
NX 12
Vericut 9.0.1
Offline
#2 2005-06-01 19:20:46
- BryanJ
- VERICUT Specialist
- From: Irvine, CA
- Registered: 2004-10-05
- Posts: 84
- Website
Re: A new guy
Hi DC,
Welcome to the forum.
You can find the training schedule at:
http://www.cgtech.com/training/training_fm.htm
Nice car!
Bryan
Offline
#3 2005-06-01 23:39:29
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: A new guy
You can also help yourself until the training by accessing the training sessions in the help.
In VERICUT, Help > On VERICUT > Training Sessions
All the necessary files are installed with the software.
Welcome and good luck
Offline
#4 2005-06-02 10:38:21
- DC Gorn
- Senior Member
- Registered: 2005-06-01
- Posts: 20
Re: A new guy
Thanks SergeV
Just finished session one
NX 12
Vericut 9.0.1
Offline
#5 2005-06-02 11:11:37
- Joeyls319
- Member
- From: Horseheads n.y.
- Registered: 2004-12-18
- Posts: 40
Re: A new guy
Welcome
You 'll find the training classes quite helpful. Also I never have a problem after I call them. Those folks are real helpful. You can pick up some answer here on the forum. Just out of curiosity, what software are you using to program with.
Welcome again,
Joey
Learn something new everyday.
Offline
#6 2005-06-02 11:17:51
- Joeyls319
- Member
- From: Horseheads n.y.
- Registered: 2004-12-18
- Posts: 40
Re: A new guy
sorry about the software question. I went back and reread the thread. you'll find the mastercam interface is extremely helpful.
Joey
Learn something new everyday.
Offline
Pages: 1