VERICUT Users' Forum

igor

Senior Member

Registered: 2012-07-20

Posts: 47

Vericut Post-Processor

Hi guys,

Anyone uses the vericut post-processors or has a little knowledge about that???
I read the help, but my english isn't very well as you can see  , so I don't know if i understand perfectly this feature....
Can I develope a post-processor to translate a siemens NC-program to a Fanuc format??? I just have to set the control to call post-processor sub's with macros???

The only example of post-processor I founded in vericut samples folder is  a post to create a probe program with Inspection feature...
I am asking this, because here, we don't use CAM to create the NC-program, due to the number of logic conditions and the structure of our programs, we can't create, until now, a post for NX that meets our needs....So when we have to change the program for another machine with another control, we need to write all program again....This feature could help us, if I understand this functions hehe...

Anyone knows any information about that???

---

Igor Freitas
CNC programming
GROB - Brazil

GavinP

VERICUT Specialist

From: UK

Registered: 2004-10-14

Posts: 58

Website

Re: Vericut Post-Processor

Can I develope a post-processor to translate a siemens NC-program to a Fanuc format???

Yes, this can be done, best to contact your local office to discuss with them.

CGTech Brasil
Rua Serra de Botucatu, 22 Altos
03317-000 Tatuapé
São Paulo SP Brasil

Phone:        +55 11 4119-0907
Email:          info.brazil@cgtech.com
Support:      support.brazil@cgtech.com