VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2010-12-22 14:52:37
- Tinhman
- Member
- Registered: 2010-06-26
- Posts: 23
Cutter comp.
Good moring Guys,
Is there any way we can make the vericut to report this move ?? ( it will alarm out at the machine)
G02 G40 X-2.1375 Y-9.1641 R.5
Thanks in advance
Offline
#2 2010-12-23 11:00:13
- MustaphaC
- VERICUT Specialist
- From: Le Mans, France
- Registered: 2004-10-14
- Posts: 130
- Website
Re: Cutter comp.
You can add the following conditions to your control word/address "G40"
[attachment=0:2ar2ky1t]<!-- ia0 -->Cancel_Comp_Circular_Motion.jpg<!-- ia0 -->[/attachment:2ar2ky1t]
Mustapha
Offline
#3 2011-01-03 22:01:25
- Tinhman
- Member
- Registered: 2010-06-26
- Posts: 23
Re: Cutter comp.
Thanks a lot Boss.
Offline
Pages: 1