VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

Pages: 1

#1 2010-12-01 21:18:48

mike d
Member
Registered: 2010-10-26
Posts: 15

interface

is anyone using the mastercam to vericut interface with mastercam 5 yet?

Offline

#2 2010-12-02 20:52:27

NathanG
Member
From: Middletown, CT
Registered: 2010-11-29
Posts: 11

Re: interface

Not yet.  The X4 version of the interface does not work with X5.  A request for the Mastercam X5 SDK (Software Development Kit) was recently placed with Mastercam by the software developers.  No word on how long it will take but with a number of other users asking for the same thing I expect that it shouldn't be very long.

Offline

#3 2010-12-07 17:56:52

NathanG
Member
From: Middletown, CT
Registered: 2010-11-29
Posts: 11

Re: interface

As of today we have support for Mastercam X5 using McamV.  You will need to contact CGTech Support to get the appropriate files.  The files will be included in version 7.1

Offline

Pages: 1

Board footer