VERICUT Users' Forum

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Vericut Cutters , Shanks, Holders, and the Catia V5 to Veric

Hi Friends,

I am beginning to use the Catia V5 to Vericut interface.

I am curious as to the differences between Catia Cutters, Shanks, and Holders  definitions, and Vericut Cutters, Shanks, and Holders definitions.

Are there things that you have found do not pass thru at all?
Are there things that you have found do not pass thru properly?
Are there things that you can define in Catia that you can not define in Vericut?
Are there things that you can define in Vericut that you can not define in Catia?

Now I ask this, to see if there is some need for any enhancement, and also for me as a caution.

Thanks folks

Dave

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."